1. Raw gas (provided by Party A) Gas: Natural gas Calorific value: 8300×4.18kJ/Nm3 of natural gas Pressure: greater than 50kPa Fuel gas status: inorganic sulfur ≤2.5mg/ m3, organic sulfur ≤ 3.5mg/m3, total sulfur ≤6.0mg/ m3, moisture (dew point) ≤-60ºC Consumption: 2.5m3 /h of natural gas Air: Compressed air Air consumption: 6 m3 /h of natural gas Pressure: 0.8mpa 2.2 Gas Output Gas output is adjustable from 1 to 12 m3/h The output pressure is adjustable about 5-10kPa Output interface DN40 The composition is about 20.5%CO+41%H2+38.5%N2 2.3. Electrical parameters Total installed capacity 10KW Power supply voltage 3 phase 380V±10% Frequency 50HZ Heating power 5KW+5% The power of the dry and cold machine is 1.5KW 2.4. Control parameters Maximum furnace temperature 1100ºC Rated furnace temperature 1050ºC Temperature control accuracy ±1ºC Number of temperature control zones 1 zone Temperature control mode thyristor, zero trigger,PID regulation 2.5. Cooling water supply Relative pressure 1-2bar Flow rate 1.0m3/h Inlet temperature 25ºC Cooling water discharge adopts non-pressure drainage. 2.6. Nitrogen supply Nitrogen pressure and flow rate for cleaning equipment: ordinary nitrogen 99.9%; The pressure is about 10kPa; Flow 12m3/h 2.7. Equipment size and weight (due to equipment technology update final delivery volume and weight >=20%)
Gas producer: Gas producer furnaces are used to produce heat-absorbing gases, using natural gas/propane as feedstock gas, which is mixed with a precisely measured amount of air, and then cracked, mainly CO and H2. The cooling method is water cooling. Furnace structure: The shell is welded by high-quality low carbon steel plate, and the heating chamber is masonry by aluminum silicate refractory ceramic fiber module. The heat-resistant steel reaction tank is equipped with high-quality Ni-based catalyst. The RX gas transmission line is equipped with a ring gap cooling system and explosion-proof valve, and the cooling system is made of stainless steel. The heating element adopts annular spiral heating wire. Gas mixing - control system: The fuel gas + air mixture system is composed of a globe valve, a cold and dry machine, a filter, a pressure reducing valve, a pressure switch, a mass flow meter, a zero pressure valve, a mass flow meter, a circulation valve, a pressure gauge, a discharge valve, a check valve, an air filter, etc., and is sealed by a pipeline system. The components in the control cabinet should use the components produced by professional manufacturers such Siemens, and the cabinet is equipped with lighting devices. The component voltage in the control cabinet is 24VDC. Water cooling pipeline system: The water cooling pipeline system consists of a ring gap cooler and a sealed connection of the inlet and outlet water pipes to form a closed return water circulation system. All use temperature resistant 80 degree components, and all use 304 stainless steel material, the main bend part uses advanced stainless steel metal hose for soft connection. Very high sealing is required.